| Quantity: | |
|---|---|
Product Introduction
Our Partial Kiss-Cut Transfer Decals for Logos are engineered for precise branding on specific vehicle areas such as doors, tailgates, hoods and side panels. Each decal is kiss-cut to the exact shape of your logo or lettering and supplied with transfer tape for accurate, one-step application.
This format is ideal when you want clean, professional branding without full or partial wrap coverage. It works beautifully on curved door panels, textured surfaces and small branding zones where alignment and edge quality matter most.
Partial Coverage Targeted branding on doors, tailgates, hoods
Exact Logo Shapes Kiss-cut to your artwork contours
Transfer Tape Included Accurate placement every time
Curved Surface Friendly Cast vinyl conforms to body lines
Material | 3M / ORAFOL / Avery cast vinyl |
|---|---|
Cutting Type | Kiss-cut logo shapes with transfer tape overlay |
Transfer Tape | Application tape pre-applied for alignment |
Printing | HP Latex / UV / screen printing |
MOQ | 1 piece / 1 vehicle set |
Outdoor Life | 5-10 years depending on laminate |
Typical Coverage | Door logos, tailgate lettering, hood emblems, side panel contact info |
Adhesive | Permanent or removable cast vinyl adhesive |
Packaging | Flat-packed with protective liner |
Partial kiss-cut transfer decals are used for clean, focused branding on vehicles and equipment:
Door LogosTailgate LetteringHood EmblemsSide Panel Contact InfoFleet NumberingService Vehicle BrandingVan DecalsPromotional Campaign Logos
We print your logo onto cast vinyl, laminate with 3M overlaminate when required, and then kiss-cut precisely to the artwork outline. Transfer tape is applied so the entire logo assembly can be positioned and applied as one piece.
Masking tape, squeegee, clean cloth, hair dryer.
Mark position. Use masking tape to outline the desired location on the panel.
Clean panel. Wash and degrease the area; dry fully.
Hinge method. Tape the decal along the top edge, lift it, remove the backing, and lower into place.
Squeegee. Smooth from top to bottom and centre to edges.
Remove transfer tape. Peel back slowly at a shallow angle.
Seal edges. Press all edges firmly, especially around curves.
Measure twice and use a level to ensure straight placement.
Heat helps the vinyl conform to compound curves.
Wait 24 hours before exposing to moisture.
